Author Topic: Nano future  (Read 14014 times)

texasjungle

  • Newbie
  • *
  • Posts: 1
  • I'm a llama!
    • View Profile
Nano future
« on: March 07, 2011, 10:37:26 AM »
This product is cool, using in off-grid cottage automation environment, stuff like battery monitoring, PV, charge current, entrance gate control, stuff like that. so I would like to see, a low power sleep mode, 802.n  wifi and -20 temp range.  But for now a wired connection is fine, but bigger market if Wifi.


support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3170
    • View Profile
    • Internet Programmable PLCs
Re:Nano future
« Reply #1 on: March 11, 2011, 06:25:57 AM »
Thank you for your comments and feedback.

With an Ethernet port on the Nano-10, FMD or F-series PLCs, you can easily connect them to the Internet use an inexpensive wireless bridge or even a 3G router if the product is installed in a remote locations. We have some documents describing how to use these products which can be downloaded below:

http://www.tri-plc.com/documents/ConnectingToWifi.pdf
http://www.tri-plc.com/documents/ConnectingTo3G.pdf

The Nano-10 PLC consumes about 0.1A at 24V DC when all the inputs and outputs are off, which means about 2.4W - a lot less than that consumed by a 4W night-light bulb! That said, it is not designed to be a used in a portable consumer product, but can still be considered to be a low power device in industrial applications.
Email: support@triplc.com
Tel: 1-877-TRI-PLCS